Lantronix SLC 8000 Advanced Console Manager User Guide - Page 410

15: Command Reference Set server port to listen on/connect to (default 5201): -p, --port n Format to report: -f, --format [kmgtKMGT] Pause n seconds between reports: -i, --interval n Bind to a host, an interface or multicast address -B, --bind More detailed output: -V, --verbose Output in JSON format: -J, --json Options below are supported on client only: Set length of buffer to n (default 8 KB): -l, --length n[KMG] Use UDP rather than TCP: -u, --udp TCP window size (socket buffer size): -w, --window n[KMG] Set TCP/SCTP maximum segment size (MTU): -M, --set-mss n Set TCP/SCTP no delay, disabling Nagle's Algorithm: -N, --no-delay Set bandwidth to n bits/sec (default 1Mbit/sec,unlimited for TCP); -b, --bitrate n[KMG] Number of bytes to transmit (instead of -t): -n, --bytes n[KMG] Time in seconds to transmit for (default 10 secs): -t, --time n Set the IPv6 flow label: -L, --flowlabel n Use a 'zero copy' method of sending data: -Z, --zerocopy Omit the first n seconds: -O, --omit n Prefix every output line with this string: -T, --title str # of blocks (packets) to transmit (instead of -t/-n): -k, --blockcount Set the IP type of service, 0-255. The usual prefixes for octal and hex can be used, i.e. 52, 064 and 0x34 all specify the same value: -S, --tos n Set the IP dscp value, either 0-63 or symbolic: --dscp n Description Runs an iPerf server or client to measure network throughput. You can optionally email the output. The SLC uses iPerf version 3.X, which is incompatible with older versions (2.x). diag lookup Syntax diag lookup [email ] Description Resolves a host name into an IP address. You can optionally email the displayed information. diag loopback Syntax diag loopback [] Parameters test SLC™ 8000 Advanced Console Manager User Guide 410