Lantronix SLC 8000 Advanced Console Manager User Guide - Page 78
Gateway, Number of Probes, Interval, Default, Eth1/Eth2 DHCP, Acquired display, Precedence
View all Lantronix SLC 8000 Advanced Console Manager manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
6: Basic Parameters Number of Probes Interval Number of probes the SLC 8000 advanced console manager sends before closing a session. The default is 5. The number of seconds the SLC unit waits between probes. The default is 60 seconds. Gateway Default Eth1/Eth2 DHCPAcquired (display only) Precedence IPv6 Default IP address of the IPv4 router for this network. If this has not been set manually, any gateway acquired by DHCP for Eth1 or Eth2 displays. All network traffic that matches the Eth1 IP address and subnet mask is sent out Eth1. All network traffic that matches the Eth2 IP address and subnet mask is sent out Eth 2. If you set a default gateway, any network traffic that does not match Eth1 or Eth2 is sent to the default gateway for routing. Note: If a fail-over gateway is configured, the default gateway must be configured for fail-over and fail-back (gateways acquired through DHCP can be changed or removed). Gateway acquired by DHCP for Eth1 or Eth2. View only. Indicates which of the gateways take precedence (used as the default route). Available options are Eth1/Eth2 DHCP-Acquired and Default. The default is Eth1/ Eth2 DHCP-Acquired gateway. If the Eth1/Eth2 DHCP Gateway is selected and both Eth1 and Eth2 are configured for DHCP, the SLC unit gives precedence to the gateway acquired via Eth1. If the Precedence gateway becomes unreachable, the console manager will not install one of the other gateways as the default gateway; this must be manually configured by the user. Indicates the IP address of the IPv6 router for this network. SLC™ 8000 Advanced Console Manager User Guide 78