Lantronix SLC 8000 Advanced Console Manager User Guide - Page 98

6: Basic Parameters To configure routing settings: 1. Click the Network tab and select the Routing option. The following page displays: Figure 6-9 Network > Routing 2. Enter the following: Dynamic Routing Enable RIP RIP Version Select to enable Dynamic Routing Information Protocol (RIP) to assign routes automatically. Disabled by default. Select the RIP version. The default is 2. Static Routing Enable Static Routing Select to assign the routes manually. The system administrator usually provides the routes. Disabled by default.  To add a static route, enter the IP Address, Subnet Mask, and Gateway for the route and click the Add/Edit Route button. The route displays in the Static Routes table. You can add up to 64 static routes.  To edit a static route, select the radio button to the right of the route, change the IP Address, Subnet Mask, and Gateway fields as desired, and click the Add/Edit Route button.  To delete a static route, select the radio button to the right of the route and click the Delete Route button. 3. Click the Apply button. Note: To display the routing table, status or specific report, see the section, Status/Reports on page 341. SLC™ 8000 Advanced Console Manager User Guide 98