Lantronix SLC 8000 Advanced Console Manager User Guide - Page 89

6: Basic Parameters Rx - Fragments Rx - Oversize Rx - Jabber Rx - RxErr Rx - FCSErr Tx - Deferred Tx - Collisions Tx - Single Collision Tx - Multiple Collisions Tx - Excessive Collisions Tx - Late Tx - FCSErr All - 64 Octets All - 65-127 Octets All - 128-255 Octets All - 256-511 Octets All - 512-1023 Octets All - 1024-Max Octets Total frames received with a length of less than 64 octets and an invalid FCS. Total frames received with a length of more than MaxSize octets but with a valid FCS. Total frames received with a length of more than MaxSize Octets but with an invalid FCS. Total frames received with an RxErr signal from the PHY. This includes 10 GE MAC Termination Errors. Total frames received with a CRC error not counted in Rx - Fragments, Rx - Jabber or Rx - RxErr. The total number of successfully transmitted frames that experienced no collisions but are delayed because the medium was busy during the first attempt. This counter is applicable in half-duplex only. The number of collision events seen by the MAC not including those counted in Single, Multiple, Excessive, or Late. This counter is applicable in half-duplex only. The total number of successfully transmitted frames that experienced exactly one collision. This counter is applicable in half-duplex only. The total number of successfully transmitted frames that experienced more than one collision. This counter is applicable in half-duplex only. The number frames dropped in the transmit MAC because the frame experienced 16 consecutive collisions. This counter is applicable in half-duplex only. The number of times a collision is detected later than 512 bits-times into the transmission of a frame. This counter is applicable in halfduplex only. The number of frames transmitted with an invalid FCS. Whenever a frame is modified during transmission (e.g., to add or remove a tag) the frame's original FCS is inspected before a new FCS is added to a modified frame. If the original FCS is invalid, the new FCS is made invalid too and this counter is incremented. This can occur because frames with a bad FCS are allowed into the switch. Total frames received and/or transmitted with a length of exactly 64 octets, including those with errors. Total frames received and/or transmitted with a length of between 65 and 127 octets inclusive, including those with errors. Total frames received and/or transmitted with a length of between 128 and 255 octets inclusive, including those with errors. Total frames received and/or transmitted with a length of between 256 and 511 octets inclusive, including those with errors. Total frames received and/or transmitted with a length of between 512 and 1023 octets inclusive, including those with errors. Total frames received and/or transmitted with a length of between 1024 and MaxSize octets inclusive, including those with errors. MaxSize (the jumbo frame size) is 10240 bytes. Switch Commands Go to Switch Commands to view CLI commands which correspond to the web page entries described above. SLC™ 8000 Advanced Console Manager User Guide 89