Marantz SR6004 SR6004 / SR5004 User Manual - English - Page 19

ENGLISH CONNECTIONS FUNCTIONS NAMES AND BASIC OPERATION ADVANCED CONNECTIONS BASIC TUNER OPERATION To operate the unit from the remote controller, press the TUNE button on the remote controller so that the tuner mode is engaged. The unit shown in the illustrations is SR6004. LISTENING TO THE TUNER Frequency scan step for AM is selectable. Default setup is 10 kHz step, if your country's standard is 9 kHz step, Press BAND button on the front panel or BAND button on the remote controller more than 5 seconds. Scan step will change. Note • Preset memory for the tuner will clear by changing this setup. AUTO TUNING 1. 3. 2. 2. Press the BAND button to select either FM or AM. 3. Press the 3 or 4 cursor buttons on the front Panel for more than 1 second to start the auto tuning function. 4. Automatic searching begins then stops when a station is tuned in. (Using the remote controller) 1. To select tuner, Press the TUNE button twice within two second on the remote controller. 2. Press the BAND button to select either FM or AM. 3. Press and hold the TUNE 3 or 4 button for 1 second or more. 4. Automatic searching begins then stops when a station is tuned in. If tuning does not stop at the desired station, use to the "Manual tuning" operation. MANUAL TUNING 1. 3. 2. (Using the unit) 1. Turn the INPUT SELECTOR knob to select "TUNER". 2. Press the BAND button to select either FM or AM. 3. Press the 3 or 4 cursor buttons on the front Panel to select the desired station. (Using the remote controller) 1. To select tuner, press the TUNE button twice within two seconds on the remote controller. 2. Press the BAND button to select either FM or AM. 3. Press the TUNE 3 or 4 button to tune in the deseired station. DIRECT FREQUENCY CALL 1. 2. 3. BASIC OPERATION (FM) TUNING MODE (AUTO STEREO OR MONO) When in the auto stereo mode, "AUTO" indicator will be illuminated on the display. The "ST" indicator is illuminated when a stereo broadcast is tuned in. At open frequencies, the noise is muted and the "TUNED" and "ST" indicators are not illuminated. If the signal is weak, it may be difficult to tune into the station in stereo. In such a case, Press the T.MODE button on the front panel or T.MODE button on the remote controller. "AUTO" indicator is not illuminated, if FM stereo broadcasts are received in monaural and the "ST" indicator is not illuminated. To return to auto stereo mode, Press the T.MODE button on the front panel or T.MODE button on the remote controller again. "AUTO" indicator is illuminated the display. 4. 1. 3. 2. (Using the unit) 1. Turn the INPUT SELECTOR knob to select "TUNER". 1. To select tuner, press the TUNE button twice within two seconds on the remote 1. controller. 2. Press the BAND button to select either FM or AM. 3. Press the F.DIRECT on the remote controller, 3. display will show "FREQ----". 4. lnput your desired station's, frequency with the ten numbered keypad on the remote controller. 2. 5. The desired station will automatically be tuned. 17 SETUP ADVANCED OPERATION TROUBLESHOOTING OTHERS