Marantz SR6004 SR6004 / SR5004 User Manual - English - Page 71
Sr6004 Remote Controller, Basic Operation
View all Marantz SR6004 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
CONNECTIONS FUNCTIONS NAMES AND BASIC BASIC OPERATION ENGLISH SR6004 REMOTE CONTROLLER BASIC OPERATION NORMAL MODE (When operating Marantz AV equipment products) This remote controller is preset with a total of 12 types of remote codes, including Marantz BD, DVD, VCR (VCR deck), DSS (Satellite broadcasting tuner), TV (Television), CD, CDR, AUX, TUNER, USB, M-XP and AMP mode. Learning is not necessary for Marantz products. You can use these products without setting any codes. 1. Press the SOURCE button. For this example, press DVD. Pressing the SOURCE button once changes the remote control to the settings for the source that was pressed. To change the amplifier on other source, press the SOURCE button twice (doubleclick). The code is sent, and then the amplifier source changes to DVD. SETTING THE BACK LIGHT Pressing the Light button located on the side of the remote controller lights the remote controller's backlight. Pressing the button again while the backlight is lit lights the backlight for another 2 seconds. To turn off back light, press and hold down the SET and OFF button until indicator blinks twice. To turn on it again, press and hold down the SET and ON button until indicator blinks twice. Initial is back light ON. PRESET MODE (When operating non-Marantz AV equipment products) This remote controller is preset with remote control codes from AV equipment by other manufacturers. The preset codes are TV, CD, DVD and DSS. Settings can be made in one of two ways. When the preset codes are set, the following codes are contained in the source button of the remote controller. See the attached manufacturer number list for the preset manufacturers, devices, preset numbers, and other settings. Remote controller source name Corresponding preset code Device name TV TV Television DVD DVD DVD player CD CD CD player Satellite DSS SATELLITE broadcasting tuner equipment BD BD Blu-ray disc player Importants • Some codes may be not match your equipment. In this case, you can use LEARN mode to store these codes. • The preset codes do not cover full functions. If you need extra function, use LEARN mode to store extra function. • When the batteries are getting weak, the preset procedure is not successful. PROGRAMMING WITH THE 4-DIGIT CODE 1. 2. 1. 1. Press and hold down the SOURCE button for the appliance which should be controlled and press SET button until the indicator blinks twice. Then back light flushes. 2. Press the 4-digit code by numeric buttons for appliance (code table at the end of this book) Display 4-digit code on the LCD. When the procedure is successful, "OK" is displayed on the LCD. Note If "NG" is displayed on the LCD, then repeat steps 1 through 2 and try entering the same code again. ADVANCED OPERATION SCANNING THE CODE TABLE 2. 3. 2. 3. 5. 1. Switch on the appliance which should be controlled. 2. Press and hold down the SOURCE button for appliance which should be controlled and press SET button until the indicator blinking twice. Then back light flushes. 3. Aim the remote control at the appliance and slowly alternate between pressing INPUT 3 button and the SOURCE ON/OFF button for the appliance. Display the setup number on the LCD. 4. Stop when the appliance turns off. 5. Press ENTER button once to lock in the code. ADVANCED CONNECTIONS SETUP ADVANCED OPERATION TROUBLESHOOTING OTHERS 69