Marantz SR6004 SR6004 / SR5004 User Manual - English - Page 32
Error Messages
View all Marantz SR6004 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
NAMES AND FUNCTIONS CONNECTIONS BASIC ENGLISH SETUP ERROR MESSAGES Mic Setup Error!! Displayed Error Audyssey MultEQ Setup Start Front Height Surround Back : Yes : 2ch Return Mic Setup Error Check Microphone Cause • The microphone is not properly connected. How to Remedy • Connect the included microphone. • Check the microphone connection. Noise Error!! : : Enter : Audyssey MultEQ Setup Speaker Check : * * Noise Error!! Exit : Exit • There is too much noise in the listening room to measure properly. • Volume from the speakers is low. • During measurement, turn off devices that make noise such as air conditioners. • Measure at a time when the surrounding area is quiet. BASIC OPERATION ADVANCED CONNECTIONS SETUP ADVANCED OPERATION TROUBLESHOOTING Analyze Error!! * Under Analyze Error, select "Result" with the 3/4 cursor buttons and press the ENTER button. A detail screen like the following appears on the display. 30 : : Enter : Audyssey MultEQ Setup Speaker Check : * * Analyze Error!! Result Return Exit : Exit : Up / Down : Enter : Return Exit : Exit Speakers Configuration Check Speaker Results Front Left : Yes Front Height Left : No Center : No Front Height Right : No Front Right : Yes Surround Right : No Surround Back Right : Yes Surround Back Left : Yes Surround Left : No Subwoofer : Yes Return : : Rev Rev Err Err Enter : Return Exit : Exit • The speakers required for suitable playback were not detected. • Speaker polarity is connected backwards. In the examples at left, the following trouble is detected. • The polarity of the left and right channels of the front speakers is backwards ([Rev] appears on the display.) • The surround speaker is not connected ([No] is displayed), but the surround back speaker is connected An error is indicated in addition to the above if the speakers are connected as follows. • When using just one surround back speaker, but it is connected to the surround back R-channel (To use just one surround back speaker, connect it to the L-channel.) • Power off the unit and check the speakers that are indicated as reversed polarity. ([Rev] may appear with some speakers even if properly connected. If you are certain the wiring is correct, ignore the error indication and continue.) • Check speaker direction and layout OTHERS