Marantz SR6004 SR6004 / SR5004 User Manual - English - Page 57

CONNECTIONS FUNCTIONS NAMES AND BASIC BASIC OPERATION ADVANCED CONNECTIONS ENGLISH PRESET SCAN 1. CLEARING STORED PRESET CHANNELS You can remove preset channels from the memory using the following procedure. 2. 3. 5. 2. 3. 6. 1. Press the TUNE button twice within two seconds on the remote controller. 2. Press the BAND button to select SIRIUS band. 3. press the P.SCAN button on the remote controller. 4. Preset channels are recalled in sequence (No.1 → No.2 → etc.) for about 10 seconds each. The time changes by the received condition. No stored preset number will be skipped. 5. Pressing the 2 cursor button during prescanning speeds up scanning. Also, pressing the 1 cursor button returns to the previous preset channel. 6. When the desired preset channel is received, cancel the preset scan operation by press the P.SCAN button. 2. 3. 1. Recall the preset number to be cleared with the method described in "PRESET SEARCH MODE". 2. Press the MEMORY button on the front panel or the MEMO button on the remote controller. 3. The stored preset number blinks in the display for 5 seconds. WhiIe blinking, press the CLEAR button on the front panel or CLR button on the remote controller. 4. "xx CLEAR" appears on the dispIay to indicate that the specified preset number has been cleared. Note • To clear all stored preset channels, press and hold the T-MODE and the ENTER buttons on the unit for two seconds. PARENTAL LOCK This function is used to lock channels you do not want to receive. SETTING/RELEASING PARENTAL LOCK 3. 5. 2. 5. 3. 5. 2. 3. 5. 1. Tune to the channel that you want to set parental lock. 2. Press the T.MODE button on the unit or the P.LOCK button on the remote controller. PASSWORD 3. When [PASSWORD ****] appears, use the cursor buttons on the unit or remote controller, or the numeric buttons on the remote controller, to enter a password (4 digits), then press the ENTER button on the unit or the remote controller. 7 7 7 7 7 7 7 7 7 7 ADVANCED OPERATION Note The password is set to 9999 when shipped from the factory. PASWORD OK! 7 7 7 SR001 abcdefg 4. When the correct password is entered, [PASSWORD OK!] is displayed and the display flashes "✔" or ":". 5. Set parental lock on/off using the 3 / 4 cursor buttons on the unit or remote controller, then confirm the setting using the ENTER button on the unit or remote controller. "✔" Lock status ":" Unlock status You can unlock all locked channels at this time by pressing the CLEAR button on the unit or CLR button on the remote controller for 5 seconds. When "ALL UNLOCK?" is displayed, press the ENTER button on the unit or remote controller. "UNLOCKING.." is displayed and all locked channels are unlocked. Notes • If you mistakenly enter the wrong password, you will be asked to reenter the password. • You can exit parental lock mode using the EXIT button on the unit or CLR button on the remote controller. • No sound will be output when you tune to a locked channel. • Although parental lock can be set for more than one channel, all channels will share the same password. • You cannot set Parental Lock for Channel 0.
SETUP ADVANCED OPERATION TROUBLESHOOTING OTHERS 55