Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 101

NETGEAR Managed Switches Software Administration Manual, Release 8.0 • RIPv2 defined in RFC 1723 - Route specification is extended to include subnet mask and gateway - The routing table is sent to a multicast address, reducing network traffic - An authentication method is used for security The 7000 Series Managed Switch supports both versions of RIP. You may configure a given port to: • Receive packets in either or both formats. • Transmit packets formatted for RIPv1 or RIPv2 or send RIPv2 packets to the RIPv1 broadcast address. • Prevent any RIP packets from being received • Prevent any RIP packets from being transmitted. This example adds support for RIPv2 to the configuration created in the base VLAN routing example. A second router, using port routing rather than VLAN routing, has been added to the network. Layer 3 Switch Port 1/0/2 VLAN Router Port 1/3/1 192.150.3.1 Router port 1/0/5 192.150.4.1 Port 1/0/3 VLAN Router Port 1/3/2 192.150.4.1 Router Layer 2 Switch Layer 2 Switch VLAN 10 Figure 7-8 VLAN 20 Routing Information Protocol 7-9 v1.0, October 2009