Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 435

NETGEAR Managed Switches Software Administration Manual, Release 8.0 e. Select Disable in the EUI64 field. f. Click Add. Create an IPv6 Network Interface The IPv6 network interface is the logical interface used for in-band connectivity with the switch via any of the switch's front panel ports. The configuration parameters associated with the switch's network interface do not affect the configuration of the front panel ports through which traffic is switched or routed. To access the switch over an IPv6 network you must first configure it with IPv6 information (IPv6 prefix, prefix length, and default gateway). CLI: Configure the IPv6 Network Interface (Netgear Switch) #network ipv6 enable (Netgear Switch) #network ipv6 address 2001:1::1/64 (Netgear Switch) #network ipv6 gateway 2001:1::2 (Netgear Switch) #show network Interface Status Always Up IP Address 0.0.0.0 Subnet Mask 0.0.0.0 Default Gateway 0.0.0.0 IPv6 Administrative Mode Enabled IPv6 Prefix is FE80::2FF:F9FF:FE70:485/64 IPv6 Prefix is 2001:1::1/64 IPv6 Default Router 2001:1::2 Burned In MAC Address 00:FF:F9:70:04:85 Locally Administered MAC address 00:00:00:00:00:00 MAC Address Type Burned In Configured IPv4 Protocol None Configured IPv6 Protocol None IPv6 AutoConfig Mode Disabled Management VLAN ID 1 Web Interface: Configuring the IPv6 Network Interface To use the Web interface to configure the IPv6 network interface, proceed as follows: 1. Add an IPv6 address to the network interface. a. From the main menu, select System > Management >Network Interface>IPv6 Network Configuration. A screen similar to the following displays. IPv6 Interface Configuration v1.0, October 2009 27-4