Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 22

NETGEAR Managed Switches Software Administration Manual, Release 8.0 Table 1-1. Quick Start Commands (continued) Command Mode copy system:runningconfig nvram:startupconfig Privileged EXEC reload (or cold boot Privileged the networking device) EXEC Description Enter yes when the prompt asks if you want to save the configurations made to the networking device. Enter yes when the prompt asks if you want to reset the system. You can reset the networking device or cold boot the networking device. Both work effectively. Loading Firmware Using the Boot Menu This section contains procedures to help you load firmware using utility menu in case the switch fails to boot up normally and unable to login the CLI User EXEC prompt , that means you cannot use the CLI command to download the new firmware to the switch. 8.0 supports load firmware by xmodem and USB. USB is new feature in 8.0 and it downloads firmware more quickly than does xmodem. Note: The following is only be operated through serial port 1. Power cycle the switch , the following message displays: NetGear Boot code...... Version 01.00.18 06-24-2009 CPU Card ID: 0x508541 Select an option. If no selection in 10 seconds then operational code will start. 1 - Start operational code. 2 - Start Boot Menu. Select (1, 2):2 2. Enter 2 when you see Select(1,2): to display the Boot Menu as well. Boot Menu Options available 1 - Start operational code 1-9 Getting Started v1.0, October 2009