Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 353

NETGEAR Managed Switches Software Administration Manual, Release 8.0 The example is shown as CLI commands and as a Web interface procedure. CLI: Specifying the Source (Mirrored) Ports and Destination (Probe) (Netgear Switch)#config (Netgear Switch)(Config)#monitor session 1 mode Enable mirror (Netgear Switch)(Config)#monitor session 1 source interface 1/0/2 Specify the source interface. (Netgear Switch)(Config)#monitor session 1 destination interface 1/0/3 Specify the destination interface. (Netgear Switch)(Config)#exit (Netgear Switch)#show monitor session 1 Session ID Admin Mode Probe Port Mirrored Port 1 Enable 1/0/3 1/0/2 Web Interface: Specifying the Source (Mirrored) Ports and Destination (Probe) To use the Web interface to show monitor session, proceed as follows: 1. From the main menu, select Monitoring > Mirroring>Port Mirroring. A screen similar to the following displays. Figure 17-2 2. Under Multiple Port Mirroring, scroll down to interface 1/0/2 and select the checkbox for 1/0/2. The value 1/0/2 now appears in the Interface field at the top. 3. Enter the following information in the Status Table. • In the Destination Port field, enter 1/0/3. • Select Enable in the Session Mode field. 4. Click Apply. Tools v1.0, October 2009 17-7