Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 237

NETGEAR Managed Switches Software Administration Manual, Release 8.0 Attach the defined policy to interfaces 1/0/1 through 1/0/4 in the inbound direction. (Netgear Switch) (Config)#interface 1/0/1 (Netgear Switch) (Interface 1/0/1)#service-policy in internet_access (Netgear Switch) (Interface 1/0/1)#exit (Netgear Switch) (Config)#interface 1/0/2 (Netgear Switch) (Interface 1/0/2)#service-policy in internet_access (Netgear Switch) (Interface 1/0/2)#exit (Netgear Switch) (Config)#interface 1/0/3 (Netgear Switch) (Interface 1/0/3)#service-policy in internet_access (Netgear Switch) (Interface 1/0/3)#exit (Netgear Switch) (Config)#interface 1/0/4 (Netgear Switch) (Interface 1/0/4)#service-policy in internet_access (Netgear Switch) (Interface 1/0/4)#exit Set the CoS queue configuration for the (presumed) egress interface 1/0/5 such that each of queues 1, 2, 3 and 4 get a minimum guaranteed bandwidth of 25%. All queues for this interface use weighted round robin scheduling by default. The DiffServ inbound policy designates that these queues are to be used for the departmental traffic through the assign-queue attribute. It is presumed that the switch will forward this traffic to interface 1/0/5 based on a normal destination address lookup for internet traffic. (Netgear Switch) (Config)#interface 1/0/5 (Netgear Switch) (Interface 1/0/5)#cos-queue min-bandwidth 0 25 25 25 25 0 0 0 (Netgear Switch) (Interface 1/0/5)#exit (Netgear Switch) (Config)#exit Web Interface: DiffServ To use the Web interface to configure diffserv, proceed as follows: 1. Enable Diffserv. Differentiated Services v1.0, October 2009 13-4