Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 83

NETGEAR Managed Switches Software Administration Manual, Release 8.0 Adding a Static Route If your network switch has multiple routing interface that would allow different forwarding path to be taken for reaching the same destination, it may make sense to create static route to force the packet to take certain route (port) instead of the default route. The following procedure shows how to add static route to the switch routing table. CLI Command Procedure: The following commands assume the switch has already defined a routing interface with network address of 10.10.10.0, and configured that all packets destined for network 10.10.100.0 take the path of routing port. (FSM7328S) #show ip route Total Number of Routes 1 Network Subnet Next Hop Next Hop Address Mask Protocol Intf IP Address 10.10.10.0 255.255.255.0 Local 1/0/3 10.10.10.1 To delete the static route, simply add "no" keyword in the front of the "ip route" command. Web Interface Procedure To configure a static route: 1. Go to Routing > Routing Table > Route Configuration to display the Route Configuration page. Figure 5-7 Port Routing 5-8 v1.0, October 2009