Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 186

NETGEAR Managed Switches Software Administration Manual, Release 8.0 b. Under Configure Routes, make the following selection and enter the following information: • Select Static in the Route Type field. • In the Network Address field, enter 192.168.30.0. • In the Subnet Mask field, enter 255.255.255.0. • In the Next Hop IP Address field, enter 192.168.200.1. c. Click Add. Configure Isolated VLANs on a Layer 3 Switch by Using ACLs Server Port 11/0/38 10.100.5.34 10.100.5.252 Layer 3 Switch Port 1/0/24 192.148.24.1 Port 1/0/48 192.148.48.1 PC1 PC2 192.148.24.2 Figure 11-27 192.148.48.2 This example shows how to isolate VLANs on a Layer 3 switch by using ACLs. In this example, PC1 is in VLAN 24, PC2 is in VLAN 48, and server is in VLAN 38. PC1 and PC2 are isolated by an ACL but can both access the server. The example is shown as CLI commands and as a Web interface procedure. 11-26 v1.0, October 2009 Access Control Lists (ACLs)