Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 231

NETGEAR Managed Switches Software Administration Manual, Release 8.0 Note: The Traffic Class value range is instead of because queue 7 is reserved in a stacking build for stack control, and is therefore not configurable by the user. Web Interface: Setting CoS Trust Mode of an Interface To use the Web interface to set CoS trust mode of an interface, set Cos Trust Mode to dot1p of the interface 1/0/3: 1. From the main menu, select QoS > Advanced >CoS Configuration. A screen similar to the following displays. Figure 12-6 2. Under CoS Configuration, Select the Interface radio button. 3. Select 1/0/3 in the interface field. 4. Select trust dot1p in the Interface Trust Mode field. 5. Click the Apply to save the settings. Configure Traffic Shaping This section describes the Traffic Shaping feature. Traffic shaping controls the amount and volume of traffic transmitted through a network. This has the effect of smoothing temporary traffic bursts over time. Use the traffic-shape command to enable traffic shaping by specifying the maximum transmission bandwidth limit for all interfaces (Global Config) or for a single interface (Interface Config). Class of Service (CoS) Queuing v1.0, October 2009 12-9