Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 82

NETGEAR Managed Switches Software Administration Manual, Release 8.0 CLI: Add a Default Route (FSM7338S) (Config) #ip route default ? Enter the IP Address of the next router. (FSM7328S) (Config)#ip route default 10.10.10.2 Note that IP subnet "10.10.10.0" should be configured via either Port Routing Configuration example either or VLAN Routing Configuration in the next chapter. See Web Interface: Add a Default Route 1. Go to Routing > Routing Table > Route Configuration. The Route Configuration page displays. Figure 5-6 1. From the Route Type drop down menu, select DefaultRoute. 2. Enter one of the routing interface's IP addresses in the Next Hop IP Address field. • The Network Address and Subnet Mask fields will not accept input as they are not needed. • The Preference field is optional. A value of 1 (highest) will be assigned by default if not specified. 3. Click the Add button on the bottom of the page. This creates the Default Route entry into the route table. 5-7 Port Routing v1.0, October 2009