Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 24

NETGEAR Managed Switches Software Administration Manual, Release 8.0 The utility displays the following text when you enter the ezconfig command (FSM7352S) >ezconfig NETGEAR EZ Configuration Utility Hello and Welcome! This utility will walk you through assigning the IP address for the switch management CPU. It will allow you to save the changes at the end. After the session, simply use the newly assigned IP address to access the Web GUI using any public domain Web browser. Admin password not defined. Do you want to change the password? (Y/N/Q) Note: At any point in the setup, you can type Q to abort the program. At this point, Ezconfig will check if there is any change, and prompt you if the changes should be saved. Changing the Password The first question it will ask is whether you wish to change the admin password. For security reasons, you should change the password by typing Y. If you have already set the password and do not wish to change it again, just enter N. Enter new password:******** Confirm new password:******** Password Changed! The 'enable' password required for switch configuration via the command line interface is currently not configured. Do you wish to change it (Y/N/Q)? y Enter new password:******** Confirm new password:******** Password Changed! Setting Up the Switch IP Address After the password for both Admin and Enable mode is changed, you will be prompted to setup the IP 1-11 v1.0, October 2009 Getting Started