Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 387

NETGEAR Managed Switches Software Administration Manual, Release 8.0 3. In the Client Address field, enter 0.0.0.0. 4. In the Client IP Mask field, enter 0.0.0.0. 5. Select the Read/Write in the Access Mode field. 6. Select the Enable in the Status field. 7. Click the Add. Enable SNMP Trap The example is shown as CLI commands and as a Web interface procedure. CLI: Enabling SNMP Trap This example shows how to send SNMP trap to the SNMP server. (Netgear switch) #config (Netgear switch) (Config)# snmptrap public 10.100.5.17 Enable send trap to SNMP server 10.100.5.17 (Netgear switch) (Config)#snmp-server traps linkmode Enable send link status to the SNMP server when link status changes. Web Interface: Enabling SNMP Trap To use the Web interface to add a new community, proceed as follows: 1. Enable send SNMP trap to the server 10.100.5.17. a. From the main menu, select System > SNMP>SNMP V1/V2>Trap Configuration. A screen similar to the following displays. Figure 20-2 b. In the Community Name field, enter public. c. Select SNMPv1 in the Version field. SNMP v1.0, October 2009 20-2