Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 145

NETGEAR Managed Switches Software Administration Manual, Release 8.0 5. Enable OSPF on the VLAN 20. a. From the main menu, select Routing > OSPF > Advanced>Interface Configuration. A screen similar to the following displays. Figure 8-49 b. Under the Interface Configuration, click the VLANS to show all the VLAN interfaces. c. Under IP Interface Configuration, scroll down to interface 0/2/2 and select the checkbox for that interface. 0/2/2 now appears in the Interface field at the top. • In the OSPF Area ID field, enter 0.0.0.3. • Select the Enable in the OSPF Admin Mode field. • In the Priority field, enter 255. • In the Metric Cost field, enter 64. d. Click Apply to save the settings. OSPFv3 (Open Shortest Path First) OSPFv3 is the Open Shortest Path First routing protocol for IPv6. It is similar to OSPFv2 in its concept of a link state database, intra/inter area, and AS external routes and virtual links. It differs from its IPv4 counterpoint in a number of respects, including the following: peering is done via link-local addresses; the protocol is link-based rather than network-based; and addressing semantics have been moved to leaf LSAs, which eventually allow its use for both IPv4 and IPv6. Point-to-point links are also supported in order to OSPF v1.0, October 2009 8-40