Netgear FSM726v3 7000 Series Managed Switch Administration Guide for Software - Page 25

NETGEAR Managed Switches Software Administration Manual, Release 8.0 address of the switch. Assigning an IP address to your switch management Current IP Address Configuration IP address: 0.0.0.0 Subnet mask: 0.0.0.0 Would you like to assign an IP address now (Y/N/Q)? y IP Address: Ezconfig will display the current IP address and subnet mask. By default, the network management IP address uses DHCP protocol to have a DHCP server assign its IP address automatically. However, you can overwrite the DHCP client mode by assigning a fixed IP address here. Once a fixed IP address is assigned, Ezconfig automatically disables DHCP client mode and assigns the static IP address to the management VLAN. If an IP address is already assigned, and you do not wish to change the IP address again, simply type N. Assigning Switch Name and Location Information Ezconfig will proceed to the next step in the setup: Do you want to assign switch name and location information (Y/N/Q)? System Name: Alpha1-1 System Location: Bld1 System Contact: James There are changes detected, do you wish to save the changes permanently (Y/N)? Note: The System Name, System Location and System Contact fields accept only alphanumeric characters, characters like "#$..." are not supported. The maximum length of the value cannot be longer than 31 bytes. Saving the Configuration After the name and location values are entered, Ezconfig will ask if you would like to have the changes be Getting Started v1.0, October 2009 1-12