Onkyo TX SR805 Owner Manual - Page 107

Zone 2 and Zone 3-Continued Using the Remote Controller in Zone 2/3 and Multiroom Control Kits To control the AV receiver with the remote controller while you're in Zone 2 or Zone 3, you'll need a commercially available multiroom remote control kit for each zone. • Multiroom kits are made by Niles and Xantech. These kits can also be used when there isn't a clear line of sight to the AV receiver's remote sensor, such as when it's installed inside a cabinet. Using a Multiroom Kit with Zone 2/3 In this setup, the IR receiver in Zone 2/3 picks up the infrared signals from the remote controller and feeds them through to the AV receiver in the main room via the connecting block. Connecting block IR Receiver Remote controller Main room Zone 2/3 Signal flow The miniplug cable from the connecting block should be connected to the AV receiver's IR IN jack, as shown below. From the connecting block Miniplug cable IR IN OUT AV receiver Using a Multiroom Kit with a Cabinet In this setup, the IR receiver picks up the infrared signals from the remote controller and feeds them to the AV receiver located in the cabinet via the connecting block. IR IN Connecting block IR Receiver Inside cabinet Signal flow Remote controller Using a Multiroom Kit with Other Components In this setup, an IR emitter is connected to the AV receiver's IR OUT jack and placed in front of the other component's remote control sensor. Infrared signals received at the AV receiver's IR IN jack are fed through to the other component via the IR emitter. Signals picked up by the AV receiver's remote control sensor are not output. IR IN IR OUT Connecting block AV receiver IR Emitter IR Receiver Remote controller Other component Signal flow The IR emitter should be connected to the AV receiver's IR OUT jack, as shown below. Miniplug cable Other component IR IN Miniplug OUT AV receiver Signal flow Emitter IR Emitter Remote control sensor 107