Onkyo TX SR805 Owner Manual - Page 111

R EVEL MUTING DISC TAPE CH SEL Controlling Other Components-Continued Learning Commands The AV receiver's remote controller can learn the commands of other remote controllers. By transmitting, for example, the Play command from your CD player's remote controller, the remote controller can learn it, and then transmit the exact same command when its Play [ ] button is pressed in the CD remote mode. This is useful when you've entered the appropriate remote control code (page 108) but some buttons don't work as expected. 1 1, 4 ON STANDBY TV INPUT DVD 1 VCR/DVR CBL/SAT 2 3 GAME/TV AUX1 AUX2 4 5 6 + TV CH - TAPE TUNER CD 7 8 9 PHONO D. TUN TV VOL +10 0 CLEAR --/--- 10 11 12 INPUT SELECTOR MACRO 1 2 3 ZONE3 DVD REMOTE MODE VCR CD CDR/MD ZONE2 TV DIMMER + CH DISC ALBUM - PREV CH DISPLAY CABLE SAT TOP MENU DOCK MENU RECEIVER TAPE/AMP SLEEP ENTER VOL GUIDE SETUP EXIT RETURN MUTING Remote indicator 1 REMOTE MODE DVD VCR CD TV CDR/MD CABLE SAT RECEIVER TAPE/AMP DOCK While holding down the REMOTE MODE button for the mode in which you want to use the command, press the [ON] button. The Remote indicator lights up. ON 2 Press the button you want to learn the new command. 3 Point the remote controllers at each other, about 2 to 6 inches (5-15 cm) apart, and then press and hold the button whose com- mand you want to learn until the Remote indicator flashes. If the command is learned successfully, the Remote indicator flashes twice. TOTNEEST VOLUME VIDEO-2 DVGTDRAOPUEPINPTUUTTNSUEPENRLREEERCSPTEDITHOMORNMEOR MOSDUER CD INMPULUTTI-CH 4 VIDEO-1 CD SLEEP DVD POWER About 2 to 6 inches (5-15 cm) DVD SATCABLE ON + VD1CORCKRCTESDAMLRPE-OE/E-M/TA/PRI-CD2ENMEM-CDE-PPM+IAVU1ECO1RT00RDPSOEHEOLZNEOO3CNTE70O211RTAPZOENE4C83LG1E2ATARMUDEN.T/ETUVNR159 DVD AUX1 2DCR/DVR 6 AUX2 CD TV VOL STANDBY 3 CBL/SAT I - TV CH T V INPUT RC-690M To learn more commands, repeat steps 2 and 3. Press any REMOTE MODE button when you've finished. Notes: • The following buttons cannot learn new commands: REMOTE MODE, MACRO [1], [2], [3], TV [ ], TV [INPUT], TV CH [+]/[-], TV VOL [ ]/[ ], Light. • The remote controller can learn approximately 70 to 90 commands, although this will be less if commands that use a lot of memory are learned. • Remote controller buttons such as Play, Stop, Pause, and so on are preprogrammed with commands for controlling Onkyo CD players, cassette decks, and DVD players. However, they can learn new commands, and you can restore the preprogrammed commands at any time by resetting the remote controller (see page 109). • To overwrite a previously learned command, repeat this procedure. • Only commands from infrared remote controllers can be learned. • When the remote controller's batteries expire, all learned commands will be lost and will have to be learned all over again, so don't discard your other remote controllers. 111