Pioneer VSX 82TXS Owner's Manual - Page 69

Using other functions 10 Checking your system settings Use the status display screen to check your current settings for features such as surround back channel processing and your current MCACC preset. AUDIO SUBTITLE HDD DISP CH PHOTO STATUS SIGNAL SEL SBch DVD CH STEREO MULTI OPE THX STANDARD ADV. SURR SHIFT PHASE MCACC S.DIRECT 1 Press STATUS to check the system settings. These appear on both the OSD and the front panel display.1 S TAT U S 96kHz STEREO Signal Select : AUTO SBch Processin : OFF Retriever : ON Video Select : OFF MCACC Position : M1 Room2/REC SEL : SOURCE Room3 : SOURCE The front panel display shows each of the following settings for two seconds each: Input source Signal select Sound Retriever MCACC Position Room 3 Listening mode Surround Back Processing Video Select Room 2 / REC SEL 2 When you're finished, press STATUS again to switch off the display. Resetting the system Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch the receiver into standby. 2 While holding down the front panel AV PARAMETER button, press and hold STANDBY/ON for about three seconds. The display shows RESET?. 3 Press the front panel ENTER button. The display shows RESET OK?. 4 Press SETUP to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings. • Note that all settings will be saved, even if the receiver is unplugged. Default system settings Setting Default HDMI Audio Amp Digital Video Conversion On Speakers A Surround Back System Normal (SBch) Speaker System Front SMALL Center SMALL Surr. SMALL SB SMALLx2 SW YES Crossover 80 Hz Bass Peak Level OFF X-Curve OFF THX Audio Setting 0-1ft. Inputs See Input function default and possible settings on page 64. Multi Room Room 2 Volume Type Room 2 Volume Variable -60 SR+ SR+ Control On/Off OFF SR+ Volume Control On/Off OFF Monitor Out OFF DSP MCACC Position Memory Surround back channel Processing Phase Control Sound Retriever Sound Delay Dual Mono DRC SACD Gain Digital Safety Effect Level 7 ch Stereo Other modes M1: MEMORY 1 ON On Off 0 frame CH1 OFF 0 dB OFF 90 50 Note 1 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on. 69 En