Pioneer VSX 82TXS Owner's Manual - Page 89
Additional information, Specifications, Cleaning the unit
UPC - 012562820453
View all Pioneer VSX 82TXS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Additional information 12 Specifications Amplifier section Continuous average power output of 140 (or 130) watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than 0.09 %** total harmonic distortion (front). Continuous Power Output (20 Hz to 20 kHz, 8 Ω, 0.09 %) Front. . . . 130 W + 130 W (82TXS), 140 W + 140 W (84TXSi) Center 130 W (82TXS), 140 W (84TXSi) Surround 130 W + 130 W (82TXS) 140 W + 140 W (84TXSi) Surround back 130 W + 130 W (82TXS) 140 W + 140 W (84TXSi) Continuous Power Output (1 kHz, 6 Ω, 1.0 %) Front. . . . 160 W + 160 W (82TXS), 180 W + 180 W (84TXSi) Center 160 W (82TXS), 180 W (84TXSi) Surround 160 W + 160 W (82TXS) 180 W + 180 W (84TXSi) Surround back 160 W + 160 W (82TXS) 180 W + 180 W (84TXSi) Total harmonic distortion 0.05 % (20 Hz to 20 kHz, 120 W, 8 Ω) (82TXS) (20 Hz to 20 kHz, 130 W, 8 Ω) (84TXSi) Audio Section Input (Sensitivity/Impedance) LINE 335 mV/47 kΩ Frequency Response (LINE 5 Hz to 100 000 Hz dB Output (Level/Impedance) REC 335 mV/2.2 kΩ Tone Control BASS 6 dB (100 Hz) TREBLE 6 dB (10 kHz) LOUDNESS 4 dB / +2 dB (100 Hz / 10 kHz) (at volume position -40 dB) Signal-to-Noise Ratio (IHF, short circuited, A network) LINE 103 dB Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)] LINE 83 dB FM Tuner Section Frequency Range 87.5 MHz to 108 MHz Usable Sensitivity Mono: 13.2 dBf, IHF (1.3 µV/75 Ω) 50 dB Quieting Sensitivity Mono: 20.2 dBf Stereo: 38.6 dBf Signal-to-Noise Ratio Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf) Distortion Stereo: 0.5 % (1 kHz) Alternate Channel Selectivity 60 dB (400 kHz) Stereo Separation 40 dB (1 kHz) Frequency Response 30 Hz to 15 kHz ± 1 dB Antenna Input 75 Ω unbalanced AM Tuner Section Frequency Range 530 kHz to 1700 kHz Sensitivity (IHF, Loop antenna 350 µV/m Selectivity 25 dB Signal-to-Noise Ratio 50 dB Antenna Loop antenna Miscellaneous Power Requirements AC 120 V, 60 Hz Power Consumption 530 W, 690 VA In standby 0.65 W AC Outlet switched) 100 W MAX. Dimensions . . . . . 420 (W) mm x 187 (H) mm x 462 (D) mm (16 9/16 (W) in. x 7 3/8 (H) in. x 18 3/16 (D) in.) Weight (without package 16.1 kg (35.5 lb) (84TXSi) 15.9 kg (35.1 lb) (82TXS) Furnished Parts Setup microphone (for Auto MCACC setup 1 AA/IEC R6P dry cell batteries VSX-84TXSi 4 VSX-82TXS 2 Remote control unit 1 Sub room remote control unit (VSX-84TXSi only 1 AM loop antenna 1 FM wire antenna 1 iPod cable 1 Warranty card 1 These operating instructions Note * Measured pursuant to the Federal Trade Commission's Trade Regulation rule on Power Output Claims for Amplifiers ** Measured by Audio Spectrum Analyzer • Specifications and the design are subject to possible modifications without notice, due to improvements. Composite Video / S-Video Section Input (Sensitivity/Impedance 1 Vp-p/75 Ω Output (Level/Impedance 1 Vp-p/75 Ω Signal-to-Noise Ratio 65 dB Frequency Response 5 Hz to 10 MHz Component Video Section Input (Sensitivity/Impedance 1 Vp-p/75 Ω Output (Level/Impedance 1 Vp-p/75 Ω Signal-to-Noise Ratio 65 dB Frequency Response 5 Hz to 100 MHz Cleaning the unit • Use a polishing cloth or dry cloth to wipe off dust and dirt. • When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers. • Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface. 89 En