Sony MZ-N707 Operating Instructions - Page 20
To stop recording, press, To cancel synchro-recording, If the recording does not start
UPC - 027242590915
View all Sony MZ-N707 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
To stop recording, press x. After you press x to stop, the recorder will automatically turn off in about 10 seconds (when using the dry battery or the rechargeable battery) or about 3 minutes (when using the AC power adaptor). To cancel synchro-recording Press . or > repeatedly until "SYNC OFF" flashes in the display in step 3, and then press ENTER. Note If you record on a previously recorded disc, the recorder is factory set to overwrite the entire contents of the disc. If you want the recording to start after the existing contents, do the procedure "Recording without overwriting existing material" (page 31) before doing step 3, "Record an MD." (page 19). To Record from the end of the current contents1) Record over partway through the previous recording1) Pause Remove the MD Press If "REC-Posi" (the record-starting position setting) is set to "From Here", press END SEARCH, and then press and slide REC to the right.1) If "REC-Posi" is set to "From End", press and slide REC to the right. N, ., or > to find the start point of recording and press x to stop. Then press and slide REC to the right. X2). Press X again to resume recording. x and open the lid.3) (The lid does not open while "TOC Edit" is flashing in the display.) 1) If "REC-Posi" is set to "From End", recording operations will always start from the end of the previously recorded material without pressing the END SEARCH button (page 31). 2) A track mark is added at the point where you press X again to resume recording while pausing; thus the remainder of the track will be counted as a new track. 3) If you open the lid while "REC-Posi" is set to "From Here", recording will begin from the top of the disc the next time you record. Check the point to start recording on the display. If the recording does not start • Make sure the recorder is not locked (page 16, 58). • Make sure the MD is not record-protected (page 16, 61). • Premastered MDs cannot be recorded over. 20-GB