Sony MZ-N707 Operating Instructions - Page 73

Messages, Error message, Meaning/Remedy

Get Sony MZ-N707 - Net MD Walkman Player/Recorder PDF manuals and user guides
UPC - 027242590915
View all Sony MZ-N707 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 73 highlights

Messages If the following messages flash in the display window, check the messages below. Error message Meaning/Remedy BLANKDISC • An MD with no recording on it is inserted. BUSY • You tried to operate the recorder while it was accessing the recorded data. , Wait until the message goes out (in rare cases, it may take a few minutes). Data Save • The MD player is recording information (sounds) from the memory to the disc. , Wait until this process is completed. Do not expose the player to any physical shock, nor disrupt power supply. DISC FULL Hi DC in • The remaining recording time on the disc is 12 seconds (stereo), 24 seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less. , Replace the disc. • Voltage of the power supply is too high (The supplied AC power adaptor or the recommended car battery cord is not used). , Use the supplied AC power adaptor or the recommended car battery cord. HOLD LOW BATT • The recorder is locked. , Slide HOLD against the arrow to unlock the recorder (page 58). • Battery is weak. , Charge the rechargeable battery or replace the dry battery (page 15). MEM OVER NAME FULL • You tried to record with the recorder placed where it receives continuous vibration. , Put the recorder on a stable place, and start recording again. • You tried to enter more than 200 letters to label a single track or disc. • You tried to enter a total of more than 1700 letters for track or disc names. , Enter a shorter name for the track, group, or disc (page 47), or set the "LP Stamp" setting to "Stamp OFF" so that "LP:" is not added at the beginning of the track name (page 28). NO BATT NO COPY NO DISC • The rechargeable battery is not inserted. , Insert a rechargeable battery. • You tried to make a copy from a disc that is protected by the Serial Copy Management System. You cannot make copies from a digitally connected source which was itself recorded using digital connection. , Use analog connection instead (page 27). • You tried to play or record with no disc in the recorder. , Insert an MD. 73-GB

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
73
-GB
Messages
If the following messages flash in the display window, check the messages below.
Error message
Meaning/Remedy
BLANKDISC
•
An MD with no recording on it is inserted.
BUSY
•
You tried to operate the recorder while it was accessing the recorded
data.
,
Wait until the message goes out (in rare cases, it may take a few
minutes).
Data Save
•
The MD player is recording information (sounds) from the memory
to the disc.
,
Wait until this process is completed. Do not expose the player to
any physical shock, nor disrupt power supply.
DISC FULL
•
The remaining recording time on the disc is 12 seconds (stereo), 24
seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less.
,
Replace the disc.
Hi DC in
•
Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
,
Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD
•
The recorder is locked.
,
Slide HOLD against the arrow to unlock the recorder (page 58).
LOW BATT
•
Battery is weak.
,
Charge the rechargeable battery or replace the dry battery
(page 15).
MEM OVER
•
You tried to record with the recorder placed where it receives
continuous vibration.
,
Put the recorder on a stable place, and start recording again.
NAME FULL
•
You tried to enter more than 200 letters to label a single track or disc.
•
You tried to enter a total of more than 1700 letters for track or disc
names.
,
Enter a shorter name for the track, group, or disc (page 47), or set
the
“
LP Stamp
”
setting to
“
Stamp OFF
”
so that
“
LP:
”
is not
added at the beginning of the track name (page 28).
NO BATT
•
The rechargeable battery is not inserted.
,
Insert a rechargeable battery.
NO COPY
•
You tried to make a copy from a disc that is protected by the Serial
Copy Management System. You cannot make copies from a digitally
connected source which was itself recorded using digital connection.
,
Use analog connection instead (page 27).
NO DISC
•
You tried to play or record with no disc in the recorder.
,
Insert an MD.