Sony MZ-N707 Operating Instructions - Page 47

Editing recorded tracks You can edit your recordings by adding/ erasing track marks or labeling tracks and MDs. Premastered MDs cannot be edited. • You cannot edit tracks on an MD that is record-protected. Before editing tracks, close the tab on the side of the MD (page 61). • If you perform an editing operation while playing, editing results will not be recorded until you stop the recorder and "TOC Edit" disappears in the display. • Do not move the recorder while "TOC Edit"* is flashing in the display. • The lid does not open until "TOC Edit" disappears in the display after editing. • When group mode is on, editing can be performed only for the tracks registered into the selected group. ∗ TOC = Table of Contents Notes • "NAME FULL" appears when you try to enter more than 1,700 characters on a disc. Enter a shorter name for the track, group, or disc, or set the "LP Stamp" setting to "Stamp OFF" when recording in MDLP mode so that "LP:" is not be added at the beginning of the track name (page 28). • When labeling a disc which has been recorded using the group function, make sure group mode is on in order to prevent the group management information from being overwritten by mistake. • If you enter the symbol "//" between the characters in disc names such as "abc//def", you may be unable to use the group function. ENTER/./ >/x/X MENU Labeling/relabeling recordings You can name tracks, groups and discs using the recorder's character palette. Available characters • Capital and small letters of the English alphabet • Numbers 0 to 9 space) Numbers of characters you can input Track, group, or disc name: Approx. 200 each Numbers of characters you can input in a disc Numbers/marks: Approx. 1,700 T MARK VOL +/- VOL +/- DELETE T MARK ENTER >/. GROUP/ CANCEL END SEARCH EDIT CAPS 47-GB