Sony MZ-N707 Operating Instructions - Page 66
Symptom, Cause/Solution, A Premastered MD is inserted - drivers
UPC - 027242590915
View all Sony MZ-N707 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Symptom Cause/Solution The recorder does not work or works poorly. • The disc is record-protected ("PROTECTED" appears). , Slide the tab (page 61). • Recording level is too small to record (when recording manually). , Pause the recorder and adjust the recording level. • A Premastered MD is inserted ("P/B ONLY" appears) when recording. , Insert a recordable MD • The recorder is operated when it is on a battery charging stand. , Remove the recorder from the battery charging stand. • You tried to turn group mode on while setting the program. , Turn group mode on before setting the program. The recorder overwrites existing materials when record. • The record starting-position setting ("REC-Posi") is set to "From Here". , Set "REC-Posi" setting to "From End". The recorder does not work while connected to the computer. • The computer does not recognize the recorder. , Verify that the recorder is correctly connected. , Place the recorder correctly on the battery charging stand. , Install the driver correctly into your computer. , Install the OpenMG software into your computer first, and then connect the recorder. "NO SIGNAL" • There is no digital signal from the portable CD player. appears in the display , When recording digitally from a portable CD player, use the when recording from AC power adaptor and disable the anti-skip function (such as a portable CD player. ESP) on the CD player (page 21). There is no recording • The AC power adaptor was unplugged or a power outage on the MD after a occurred during recording. recording operation. The lid does not open. • The power sources have been disconnected during recording or editing, or the battery have been exhausted. , Set the power sources again, or replace the exhausted battery with new ones. • The lid is not firmly closed. , Close the lid until it clicks. Then press OPEN to open the lid. No sound comes through the headphones/ earphones. • The headphones/earphones plug is not firmly connected. , Plug in the plug of the headphones/earphones firmly to the remote control. Plug in the plug of the remote control firmly to i. • Volume is too low. , Adjust the volume by pressing VOL +/-. • The plug is dirty. , Clean the plug. 66-GB