TP-Link TL-SG2424P TL-SG2424P V1 CLI Reference Guide - Page 163
lldp tlv-select
View all TP-Link TL-SG2424P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
Syntax lldp snmp-trap no lldp snmp-trap Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet) Example Enable the SNMP notification for port 1: TL-SG2424P(config)# interface gigabitEthernet 1/0/1 TL-SG2424P(config-if)# lldp snmp-trap lldp tlv-select Description The lldp tlv-select command is used to configure TLVs to be included in outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command. By default, All TLVs are included in outgoing LLDPDU. Syntax lldp tlv-select [ port-description | system-capability | system-description | system-name | management-address | port-vlan | protocol-vlan | vlan-name | link-aggregation | mac-phy-cfg | max-frame-size | power | all ] no lldp tlv-select [ port-description | system-capability | system-description | system-name | management-address | port-vlan | protocol-vlan | vlan-name | link-aggregation | mac-phy-cfg | max-frame-size | power | all ] Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet) Example Exclude "management-address" and "port-vlan-id" TLVs in LLDPDU outgoing from port 1: TL-SG2424P(config)# interface gigabitEthernet 1/0/1 TL-SG2424P(config-if)# no lldp tlv-select management-address port-vlan 153