TRENDnet TEW-453APB User Guide - Page 8
Rear Panel, Reset to Factory Defaults - wireless access point
UPC - 710931502732
View all TRENDnet TEW-453APB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Rear Panel Introduction Antenna Console port Reset Button Ethernet Power port Figure 3 Rear Panel One antenna (aerial) is supplied. Best results are usually obtained with the antenna in a vertical position. DB9 female RS232 port. This button has two (2) functions: • Reboot. When pressed and released, the Wireless Access Point will reboot (restart). • Reset to Factory Defaults. This button can also be used to clear ALL data and restore ALL settings to the factory default values. To Clear All Data and restore the factory default values: 1. Power Off the Access Point 2. Hold the Reset Button down while you Power On the Access Point. 3. Continue holding the Reset Button until the Status (Red) LED blinks TWICE. 4. Release the Reset Button. The factory default configuration has now been restored, and the Access Point is ready for use. Use a standard LAN cable (RJ45 connectors) to connect this port to a 10BaseT or 100BaseT hub on your LAN. Connect the supplied power adapter here. 5