TRENDnet TN-200 User's Guide - Page 83
Europe - EU Declaration of Conformity
View all TRENDnet TN-200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
TRENDnet User's Guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter. This products acts as a storage sever for client devices to access at any time, any place. Therefore, it doesn't have a standby mode or use a power management mode." TN‐200 / TN‐200T1 The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user. RoHS This product is RoHS compliant. Europe - EU Declaration of Conformity This device complies with the essential requirements of the Directive 2004/108/EC. The following test methods have been applied in order to prove presumption of conformity with the essential requirements of the Directive 2004/108/EC: EN 55022 : 2010 Class B EN 61000‐3‐2 : 2006 + A2 : 2009 Class A EN 61000‐3‐3 : 2008 EN 55024 : 2010 Note: This device offers EU compliant Standby mode functionality. To turn off the device, unplug it from the power outlet. © Copyright 2013 TRENDnet. All Rights Reserved. 81