Yamaha YSP-5600 Owners Manual - Page 100
AUTO SETUP Beam+Sound optimize from the IntelliBeam, Plug the IntelliBeam
View all Yamaha YSP-5600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
2 Use advanced setup (p. 85) to configure the sound reflection board. Set "YRB FL" (FL), "YRB FR" (FR), "YRB SL" (SL), and "YRB SR" (SR) to "YES" depending upon the position of the sound reflection board to be installed. Color bars are displayed across the entire TV screen. This makes it easier to recognize whether the TV screen is reflected in the panel when determining the proper angle of the panel in step 4, to the left or right. 3 Adjust the height. Adjust the height of the sound reflection board panel based on the position of the unit and the sound reflection board, as well as the listening position. See the YRB-100 Owner's Manual for more information. 4 Adjust the angle of the panel left or right. Adjust the angle of the panel so that sound beams are reflected toward the listening position. Turn on the TV and dim the lights in the room. If you see the TV screen (color bar display) reflected in the panel from your listening position, the angle of the panel is properly adjusted. See the YRB-100 Owner's Manual for more information. 5 Press the z key to turn this unit off. Press it a second time to turn this unit on again. 6 Plug the IntelliBeam microphone into this unit and then perform "AUTO SETUP" (Beam+Sound optimize) from the "IntelliBeam" menu (p. 30). Be sure that the channels (FL, FR, SL, and SR) configured for the sound reflection board are displayed for "YRB" on the SHOW RESULT screen. An asterisk (*) is displayed with a channel exhibiting poor sound beam reflection. SHOW RESULT MEASUREMENT COMPLETE. ENVIRONMENT CHECK:Success FRONT :Stereo SURROUND :Beam SUBWOOFER:Wired YRB:FL SL* [ENTER]:Save set-up. [RETURN]:Do not save set-up. Indicates poor reflection Should this occur, follow the instructions below to re-adjust the panel. a Adjust the height and angle of the sound reflection board panel in accordance with installation conditions. b Use "Channel Level" in the setup menu (p. 74) to confirm that the test sound is successfully reflected. For greater precision, perform "AUTO SETUP" in the "IntelliBeam" menu, and then confirm that the asterisk (*) is no longer displayed with the channel. If the asterisk (*) continues to be displayed, or if there is still no test sound reflected from the direction of the sound reflection board, follow directions in the YRB-100 Owner's Manual to adjust sound beams manually. APPENDIX ➤ When surround effect is not enough En 100