Yamaha YSP-5600 Owners Manual - Page 32
AUTO SETUP via the setup menu, Follow steps 4
View all Yamaha YSP-5600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
6 Remove the IntelliBeam microphone. The "AUTO SETUP COMPLETE" screen closes. The IntelliBeam microphone is sensitive to heat, so should not be placed anywhere where it could be exposed to direct sunlight or high temperatures (such as on top of AV equipment). // ENTER SETUP ( ) INTELLIBEAM MIC INTELLIBEAM MIC ❑ AUTO SETUP via the setup menu "Beam optimize only" or "Sound optimize only" can be measured separately in the setup menu. 1 Place the IntelliBeam microphone at your normal listening position, and press the SETUP ( ) key. See "Installing the IntelliBeam microphone" (p. 29) for instructions on positioning the IntelliBeam microphone. 2 Press the S/T key to select "Beam" and then press the ENTER key. 3 Press the S/T key to select "IntelliBeam" and then press the ENTER key. 4 Press the S/T key to select one of the items below and then press the ENTER key. Settings Select this optimization feature if you make Beam+Sound optimize settings for the first time. This menu takes about 3 minutes. Beam optimize only Use to optimize the beam angle so that the parameter best matches your listening environment. This menu takes about 1 minute. Sound optimize only Use to optimize the beam delay, volume, and quality so that the parameters best match your listening environment. This menu takes about 2 minutes. You must optimize the beam angle with "Beam optimize only" before starting "Sound optimize only". Select this optimization feature in the following cases: • If you have opened or closed the curtains in your listening room before using this unit • If you have manually set the beam angle with "Beam optimize only". 5 Connect the IntelliBeam microphone to this unit after "AUTO SETUP (PREPARATION & CHECK)" screen is displayed. For details on connecting IntelliBeam microphone, refer to "Using AUTO SETUP (IntelliBeam)" (p. 30). 6 Follow steps 4, 5, and 6 under "Using AUTO SETUP (IntelliBeam)" to configure settings, and then remove the microphone. • When the AUTO SETUP procedure is performed from the setup menu, the menu selection screen of the setup menu appears. Press the SETUP ( ) key twice to exit the setup menu. PREPARATIONS ➤ f Initial settings En 32