Yamaha YSP-5600 Owners Manual - Page 91
APPENDIX, Troubleshooting, Surround sound effects are
View all Yamaha YSP-5600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Problem Cause Remedy No sound. Incorrect input or output cable connections. Connect the cable properly. No appropriate input source has been selected. Select an appropriate input source with the input selector keys. The volume is turned down. Turn up the volume. The sound is muted. Press the MUTE ( ) or VOL (+/-) key to resume audio output and adjust the volume level. There is input signal cannot be played back by this unit. Play a source whose signals can be reproduced by this unit. Change the system settings of the source device. "HDMI Audio Out" is set to "TV". Set to "AMP". "HDMI Control" is set to "Off". When connecting ARC (Audio Return Channel) supported TV and this unit using an HDMI cable only, set "HDMI Control" to "On". To use this unit with "HDMI Control" set to "Off", connect the TV's audio output jack to this unit's TV (digital optical) jack via the optical cable. Sound from an HDMI control-enabled TV is set for output from the TV's built-in speakers. Use the TV's HDMI settings to set audio output to any option other than the TV's built-in speakers. No sound or too small sound from The output level of the channel is muted. a specific channel. The beam setting is inappropriate. Raise the output level of the channel. Adjust the beam setting. The source is played in stereo playback mode. Switch to 3D surround/surround playback mode. Surround sound effects are insubstantial. When connecting this unit with playback device and TV digitally, the output Refer to documentation supplied with your device and check the setting. setting of the playback device and TV is not valid. The playback device is set for constant output from 2 channels (PCM, etc.). Change the playback device's audio output setting. The listening room is not a regular shape, or the unit or listening position is Relocate the unit or listening position. not at the center of the right and left wall of the listening room. There is no wall in the path of the sound beam. Place the sound reflection board in the path of the sound beam. When "My Surround" is set to "On", listening position is not in front of the unit. Listen in front of this unit. Sounds from above cannot be clearly heard. The angle of sound beams coming from the height channels is not properly Apply 3D surround sound playback mode, and then set "Height L" and set. "Height R" for "Vertical Angle" in the setup menu to positions where audio can be more clearly heard. A playback mode other than 3D surround sound playback mode is being Use 3D surround sound playback mode for playback. used for playback. The ceiling is too high, or there are items protruding from the ceiling. Change the unit's installation position or the listening position, and then perform AUTO SETUP again. See page 23 36 36 36 106 76 76 22 - 42, 74 29, 69 37, 38 - - 13 99 73 37, 69 37 29 APPENDIX ➤ Troubleshooting En 91