Yamaha YSP-5600 Owners Manual - Page 35
HDMI1, Setting the HDMI control function, Changing the connection method and, connected devices
![]() |
View all Yamaha YSP-5600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
z HDMI 1 Setting the HDMI control function 1 Turn on the unit, TV, and playback devices. 2 Activate the HDMI control function on the unit, TV, and playback devices such as BD/DVD players that support this function. For this unit, set "HDMI Control" to "On". The default setting is "Off" (p. 76). For playback devices, refer to documentation supplied with each device. 3 Turn off the main power of the TV and then turn off the unit and playback devices. 4 Turn on the unit and playback devices and then turn on the TV. 5 Switch the TV input to display the video from the unit. 6 Select HDMI 1-4 as an input source and confirm that the video of the playback device is displayed on the TV. When the playback device is connected to the HDMI IN 1 jack, press the HDMI1 key. HDMI1 Input source name 7 Check that the unit is properly coordinated with the TV by turning off the TV or adjusting the TV volume with the TV remote control. If devices are not coordinated Confirm the settings are properly configured as described below. - "HDMI Control" (p. 76) is set to "On" in the setup menu. - The HDMI control function is enabled on the TV. The example of TV settings • From the setup menu on your TV, select "Link setting" "HDMI control setting", then set a setting such as "HDMI control function" to "ON". • Set audio output to any option other than TV. If devices fail to coordinate even after the settings described above have been applied correctly: - Turn off this unit and the TV, and then turn them back on again. - Disconnect the power cable of the unit and external devices connected to the unit via HDMI cable. Plug them in again after about 30 seconds. - If devices fail to coordinate after OPTICAL, AUX1, or AUX2 is input, repeat steps 5 and 6 under "Setting the HDMI control function". Changing the connection method and connected devices When changing connected devices, or the jacks via which devices are connected, reconfigure settings as follows. 1 Disable the HDMI control function of the TV and BD/ DVD player, turn off all connected devices, and change the connections. 2 Perform steps 1 to 7 of "Setting the HDMI control function". PREPARATIONS ➤ f Initial settings En 35
![](/manual_guide/products/yamaha-ysp5600-owners-manual-7c42ad2/35.png)