ZyXEL P-128 User Guide - Page 84

Prestige 128IMH ISDN Modem/ Router/Hub 5.1.1 Remote Node Setup Follow the procedure in Chapter 5 - Remote Node Configuration to configure the protocolindependent parameters in Menu 11 - Remote Node Profile. For the TCP/IP parameters, follow the instructions below. If you are configuring your Prestige to receive incoming calls, you also need to set the default dial-in parameters in Menu 13. Follow the steps below to edit Menu 11.3 - Remote Node Network Layer Options shown below. In Menu 11.1, make sure IP is among the protocols in the Route field. (The Route field should display Route = IP or Route = IP + IPX.) Move the cursor to the Edit IP/IPX/Bridge field, then press the space bar to toggle and set the value to Yes. Press [Enter] to open Menu 11.3 - Network Layer Options. Menu 11.3 - Remote Node Network Layer Options IP Options: Rem IP Addr: 0.0.0.0 Rem Subnet Mask= 0.0.0.0 My WAN Addr= 0.0.0.0 Single User Account= No Metric= 2 Private= No RIP Direction= Both Version= RIP -2B IPX Options: Dial-On-Query= N/A Rem LAN Net #= N/A My WAN Net #= N/A Hop Count= N/A Tick Count= N/A W/D Spoofing(min)= N/A SAP/RIP Timeout(min)= N/A Bridge Options: Dial-On-Broadcast= N/A Ethernet Addr Timeout(min)= N/A Enter here to CONFIRM or ESC t o CANCEL: Figure 5-2 Menu 11.3- Remote Node TCP/IP Options 5-2 Remote Node TCP/IP Configuration