Brother International Innov-ís 2800D Users Manual - English - Page 29
Setting the Bobbin
View all Brother International Innov-ís 2800D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
g Pass the thread through the thread guide. a LOWER/UPPER THREADING a Press the "Presser Foot Lifter" button to raise the presser foot. b Slide the bobbin cover latch to the right, and then remove the bobbin cover. 1 a b Getting Ready a Thread guide h Pass the thread under the pin on the bobbin winding pretension disk and guide, and then pass it around the pretension disk. * Make sure that the thread passes under the pretension disk. a b a Bobbin cover b Latch c Hold the bobbin with your right hand and hold the end of the thread with your left hand. a Pin b Pretension disk i Follow steps g through j on page 25. d Insert the wound bobbin into the bobbin case so that the thread unwinds in the direction of the arrow. Setting the Bobbin This section describes how to set a bobbin wound with thread into the machine. You can begin sewing without pulling up the bobbin thread. If you wish to pull up the bobbin thread, for example, when sewing gathers, follow the procedure described in the next section. CAUTION • Use a bobbin thread that has been correctly wound. Otherwise, the needle may break or the thread tension will be incorrect. CAUTION • Be sure to hold down the bobbin with your finger and unwind the bobbin thread correctly. Otherwise, the thread may break or the thread tension will be incorrect. e Lightly hold down the bobbin with your right hand, and then, while slightly pulling the thread with your left hand, guide it through the groove. 27