Brother International Innov-ís 2800D Users Manual - English - Page 82
Pull out the button holder plate on the presser
View all Brother International Innov-ís 2800D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
SEWING THE STITCHES Buttonholes are sewn from the front of the presser foot to the back, as shown below. a a a a Reinforcement stitching a Select a stitch, and then attach presser foot "A". b Mark the position and length of the buttonhole on the fabric. a d Hold the outside frame of the buttonhole foot toward the back with your finger, and then lower the presser foot so that the mark on the fabric aligns with the marks on the buttonhole foot. Memo a The maximum buttonhole length is 28 mm (approx. 11/6 inches) (diameter + thickness of the button). c Pull out the button holder plate on the presser foot, and then insert the button that will be put through the buttonhole. * The size of the buttonhole is set by positioning the button in the button holder plate. Note Pass the thread under the presser foot. Ab a Mark on fabric b Marks on presser foot Note • Slide the outside frame of the buttonhole foot backward as far as possible, making sure that there is no gap behind the part of the foot marked "A", as shown in the illustration. If the buttonhole foot is not slid back as far as possible, the buttonhole will not be sewn at the correct size. • Pass the thread under the presser foot. a a Button holder plate 80