Brother International Innov-ís 2800D Users Manual - English - Page 67

■ Overcasting Using the Side Cutter By using the side cutter, you can do overcasting while cutting the fabric. SEWING THE STITCHES CAUTION • Make sure to only select one of the stitches listed below. Using another stitch may cause the needle to hit the presser foot and break, possibly causing injury. Memo Do not use the needle threader when the side cutter is attached. Thread the needle manually, or only attach the side cutter after threading the needle using the needle threader. Stitch Stitch name Presser foot Applications Stitch width Stitch length [mm (inch.)] [mm (inch.)] Twin Auto. Manual Auto. Manual needle 3 With side cutter Straight stitch while cutting fabrics 0.0 0.0 - 2.5 2.5 0.2 - 5.0 (0) (0 - 3/32) (3/32) (1/64 - 3/16) NO Utility Stitches With side cutter Zigzag stitch while cutting fabrics 3.5 (1/8) 3.5 - 5.0 (1/8 - 3/16) 1.4 (1/16) 0.0 - 4.0 (0 - 3/16) NO With side cutter Overcasting stitch while cutting fabrics 3.5 (1/8) 3.5 - 5.0 (1/8 - 3/16) 2.0 1.0 - 4.0 (1/16) (1/16 - 3/16) NO With side cutter Overcasting stitch while cutting fabrics 5.0 (3/16) 3.5 - 5.0 (1/8 - 3/16) 2.5 1.0 - 4.0 (3/32) (1/16 - 3/16) NO With side cutter Overcasting stitch while cutting fabrics 5.0 (3/16) 3.5 - 5.0 (1/8 - 3/16) 2.5 1.0 - 4.0 (3/32) (1/16 - 3/16) NO a Follow the steps on page 34 to remove the presser foot. b Position the fork on the side cutter's operating lever onto the needle clamp screw. b c Position the side cutter so that the side cutter pin is aligned with the notch in the presser foot holder, and then lower the presser foot. ba a a Needle clamp screw b Operating lever Memo Make sure that the fork of the operating lever is set onto the needle clamp screw firmly. a Notch in presser foot holder b Pin → The side cutter is attached. 65