Compaq AP550 Compaq Professional Workstation AP550 Maintenance & Service G - Page 119
Clearing Configuration Memory
UPC - 743172976857
View all Compaq AP550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Diagnostic Tools 4-25 Table 4-12 Computer Setup continued Task Save the system configuration to a blank 1.44-MB diskette. Restore the system configuration from a diskette. Restore factory default settings and exit Computer Setup. Exit Computer Setup without applying or saving any changes. Save changes to the system configuration and exit Computer Setup. Computer Setup Selection Select File, then select Save to Floppy. Select File, then select Restore from Floppy. Select File, then select Set Defaults and Exit. Select File, then select Ignore Changes and Exit. Select File, then select Save Changes and Exit. Clearing Configuration Memory The Workstation Configuration Memory Operating System (CMOS) may occasionally be corrupted. When this occurs, it is usually due to software or hardware that is not functioning accurately, or due to the addition or removal of expansion boards. If the workstation's configuration memory becomes corrupted, it is necessary to clear the configuration memory. 1. Turn off the workstation and any external devices, and disconnect the power cord from the grounded AC outlet. 2. Disconnect the keyboard, monitor, network cable, and any other external devices connected to the workstation. WARNING: To reduce the risk of personal injury from electrical shock and/or hot surfaces, be sure to disconnect the power cord from the wall outlet, and allow the internal system components to cool before touching CAUTION: When the unit is plugged in, the power supply always has 5 volts applied to the system board even when the unit is turned off. Failure to disconnect the power cord can result in damage to the system. CAUTION: Static electricity can damage the electronic components of the computer or optional equipment. Before beginning these procedures, ensure that you are discharged of static electricity by briefly touching a grounded metal object. 3. Remove the workstation access panel.