Compaq AP550 Compaq Professional Workstation AP550 Maintenance & Service G - Page 136
Upgrading the ROM, Local ROM Flash
UPC - 743172976857
View all Compaq AP550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
4-42 Compaq Professional Workstation AP550 Maintenance and Service Guide Table 4-28 SCSI Test Error Codes continued Error Code XXXX-90 Description Fan failure XXXX-91 Over Temperature XXXX-99 Autoloader reported tapes not loaded properly Recommended Action 1. Ensure that fan(s) is connected. 2. Replace nonfunctional fan(s). 1. Ensure proper airflow. 2. Perform required maintenance and cleaning. 1. Install tape(s) in autoloader tape drive according to test instructions. 2. Change autoloader magazine. Upgrading the ROM If the Compaq Professional Workstation AP550 does not have a Setup Password enabled, the ROM is not write-protected, and unauthorized updates can occur. If you need or want to upgrade your system ROM, you can: s Order the Compaq Support Software CD Kit. s Download the latest ROMPaq images from the Compaq website: www.compaq.com IMPORTANT: To ensure maximum ROM protection, establish a Setup Password. A Setup Password prevents unauthorized ROM upgrades. Local ROM Flash To upgrade the ROM: 1. Insert the ROMPaq diskette in the diskette drive and turn on the workstation. CAUTION: To guard against unauthorized updates of the Flash ROM or the System BIOS, the Setup Password must be set. See Chapter 5 for procedures on establishing a Setup Password. 2. If prompted, enter the Setup Password. NOTE: If the Setup Password is entered correctly, the ROMPaq utility will take over and run the ROM upgrade. If the Setup Password is entered incorrectly, the procedure will terminate and no changes will be made to the ROM. 3. When the utility finishes upgrading the ROM, remove the diskette from the diskette drive, and restart the workstation. IMPORTANT: Do not turn off the power to your workstation until the ROMPaq utility has completed the upgrade process.