Compaq AP550 Compaq Professional Workstation AP550 Maintenance & Service G - Page 75
Push the processor/heatsink into the secondary processor slot until it locks firmly into
UPC - 743172976857
View all Compaq AP550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
3-42 Compaq Professional Workstation AP550 Maintenance and Service Guide 5. Pull out the retaining tabs on each side of the terminator board 1, and then lift the terminator board out of the socket 2. 2 1 1 Figure 3-36. Removing the terminator board from the secondary processor slot Figure 3-37. Installing a second processor/heatsink assembly 6. Push the processor/heatsink into the secondary processor slot until it locks firmly into place. IMPORTANT: Do not mix processors. The second processor must be the same speed, cache size, and type as the existing processor. Reassemble the workstation, and connect the power cord to the grounded AC outlet and to the workstation. IMPORTANT: Be sure to tighten both thumbscrews when replacing the workstation access panel.