Compaq AP550 Compaq Professional Workstation AP550 Maintenance & Service G - Page 54
Drivelock, Remove all drives from the computer.
UPC - 743172976857
View all Compaq AP550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Removal and Replacement Procedures 3-21 Drivelock The workstation chassis drivelocks secure the drives in both the minitower and desktop configurations. To remove the drivelocks: 1. Perform the steps in the "Service Preparations" section as previously shown. CAUTION: Before removing the workstation access panel, ensure that the workstation is turned off, all cables are disconnected from the back of the workstation, and the power cord is disconnected from the grounded AC outlet. 2. Remove the workstation access panel. 3. Remove the front bezel. 4. Remove all drives from the computer. 5. Lift the side of each drivelock nearest you and push it toward the front of the drive cage 1, then snap the tabs out of the holes in the drive cage 2. CAUTION: The spring under the drivelock may pop out unexpectedly. 6. Remove the drivelock from the drive cage. 7. Remove the spring from the drivelock 3. 1 2 3 2 Figure 3-20. Removing the drivelock