Compaq AP550 Compaq Professional Workstation AP550 Maintenance & Service G - Page 50
Install two M3 guide screws into the bottom holes on each side of the, replacement drive
UPC - 743172976857
View all Compaq AP550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
5. Raise the drivelock to unlock the drive. Removal and Replacement Procedures 3-17 Figure 3-17. Releasing the hard drive by raising the drivelock 6. Hold the drivelock in its elevated position while you push the hard drive from the rear and remove it from the front of the drive bay. Figure 3-18. Removing a 5.25-inch drive To replace the hard drive: 1. Install two M3 guide screws (Figure 3-9) into the bottom holes on each side of the replacement drive, making sure the guide screws line up with the guide slots. 2. Slide the drive into the drive bay until it snaps into place.
Removal and Replacement Procedures
3-17
5.
Raise the drivelock to unlock the drive.
Figure 3-17.
Releasing the hard drive by raising the drivelock
6.
Hold the drivelock in its elevated position while you push the hard drive from the rear and
remove it from the front of the drive bay.
Figure 3-18.
Removing a 5.25-inch drive
To replace the hard drive:
1.
Install two M3 guide screws (Figure 3-9) into the bottom holes on each side of the
replacement drive, making sure the guide screws line up with the guide slots.
2.
Slide the drive into the drive bay until it snaps into place.