Compaq AP550 Compaq Professional Workstation AP550 Maintenance & Service G - Page 97
POST Messages, Table 4-1, POST Error Messages
UPC - 743172976857
View all Compaq AP550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Diagnostic Tools 4-3 POST Messages An error message results if the POST encounters a problem. This test runs when the system is turned on, checking assemblies within the workstation and reporting any errors found. CAUTION: RIMMs can reach a temperature of 212°F (100°C) in a matter of minutes. Caution should be excised whenever removing or replacing these components. NOTE: See Chapter 2 for more information on preparing the workstation for service. Error Code 101-ROM Error 101-Option ROM Checksum Error 102-System Board Failure 103-System Board Failure 150-SafePost Active Table 4-1 POST Error Messages Audible Beeps L=Long S=Short Probable Source of Problem System ROM checksum Option ROM checksum DMA, timers, and so forth Hardware component. An add-in card in the system appeared not to work correctly. Recommended Action Contact your Compaq authorized service provider Contact your Compaq authorized service provider Contact your Compaq authorized service provider Replace the Expansion Cage System Board. Run the Computer Setup utility. Reboot the system. If add-in card requires an unusual amount of setup time, SafePost can be disabled in Computer Setup. Otherwise, remove the add-in card. continued