Compaq Armada E700 Armada E700 - Page 95
cover is attached with a standard Torx T-8 screw. Use a Torx T-8 screwdriver
View all Compaq Armada E700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
4. Remove the screw that secures the memory expansion compartment cover to the computer 1 (Figure 5-24). NOTE: If the computer was shipped with a preinstalled memory expansion board, the cover is attached with a tamper-resistant Torx T-10 memory security screw. Use the Torx T-10 screwdriver included with the computer to remove and reinsert this screw. If the computer was not shipped with preinstalled memory expansion boards, the cover is attached with a standard Torx T-8 screw. Use a Torx T-8 screwdriver to remove and reinstall the screw. 5. Slide the cover to the left 2 and lift the left edge up to remove it. Figure 5-24. Removing the Memory Expansion Compartment Cover 5-28 Removal and Replacement Procedures
5-28
Removal and Replacement Procedures
4.
Remove the screw that secures the memory expansion compartment cover to the
computer
1
(Figure 5-24).
NOTE:
If the computer was shipped with a preinstalled memory expansion board, the
cover is attached with a tamper-resistant Torx T-10 memory security screw. Use the
Torx T-10 screwdriver included with the computer to remove and reinsert this
screw.
If the computer was not shipped with preinstalled memory expansion boards, the
cover is attached with a standard Torx T-8 screw. Use a Torx T-8 screwdriver to
remove and reinstall the screw.
5.
Slide the cover to the left
2
and lift the left edge up to remove it.
Figure 5-24.
Removing the Memory Expansion Compartment Cover