Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 128
the System Configuration Utility, Read Error Occurred.
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Diagnostics and Troubleshooting 3-31 Table 3-2 POST Error Messages continued Error Code Audible Beeps 1794-Drive Array - None Array Accelerator Battery Charge Low. Array Accelerator is temporarily disabled. Array Accelerator will be re-enabled when battery reaches full charge. 1795-Drive Array - None Array Accelerator Configuration Error. Data does not correspond to this drive array. Array Accelerator is temporarily disabled. 1796-Drive Array - None Array Accelerator Not Responding. Array Accelerator is temporarily disabled. 1797-Drive Array - None Array Accelerator Read Error Occurred. Data in Array Accelerator has been lost. Array Accelerator is disabled. 1798-Drive Array - None Array Accelerator Write Error Occurred. Array Accelerator is disabled. Probable Source of Problem This is a warning that the battery charge is below 75%. Postedwrites are disabled. Recommended Action Replace the array accelerator board if batteries do not recharge within 36 power-on hours. This indicates that while the system was in use, power was interrupted while data was in the array accelerator memory. The data stored in the array accelerator does not correspond to this drive array. Match the array accelerator to the correct drive array, or run the System Configuration Utility to clear the data in the array accelerator. Array accelerator is defective or has been removed. Hard parity error while reading data from posted-writes memory. 1. Check that the array accelerator is properly seated. 2. Run the System Configuration Utility to reconfigure the Compaq IDA-2 without the array accelerator. Enable array accelerator. Hard parity error while writing data to posted-writes memory. Enable array accelerator. continued