Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 26
Casters, Remove the three T-15 screws securing each caster to the bottom of the server.
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Removal and Replacement Procedures 2-9 Casters To remove the casters: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Place the server on its side. 3. Remove the three T-15 screws securing each caster to the bottom of the server. 4. Pull the casters away from the server. Figure 2-4. Removing the casters Reverse steps 1 through 4 to replace the casters.
Removal and Replacement Procedures
2-9
Casters
To remove the casters:
1.
Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2.
Place the server on its side.
3.
Remove the three T-15 screws securing each caster to the bottom of the server.
4.
Pull the casters away from the server.
Figure 2-4.
Removing the casters
Reverse steps 1 through 4 to replace the casters.