Compaq ProLiant 8000 ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maint - Page 131
Primary Processor Test Error Codes, Table 3-3
View all Compaq ProLiant 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
3-34 Compaq ProLiant 8000 Intel Pentium III Xeon 700MHz Servers Maintenance and Service Guide 100 - 199, Primary Processor Test Error Codes The 100 series of diagnostic error codes identifies failures with processor and system board functions. Table 3-3 Primary Processor Test Error Codes Error Code 101-xx 103-xx 104-xx 105-xx 106-xx 107-xx 108-xx 109-xx 110-xx 111-xx 113-xx 114-xx 116-xx 122-xx 123-xx 199-xx Description CPU test failed. DMA page registers test failed. Interrupt controller master test failed. Port 61 error occurred. Keyboard controller self-test failed. CMOS RAM test failed. CMOS interrupt test failed. CMOS clock load data test failed. Programmable timer load data test failed. Refresh detect test failed. Protected mode test failed. Speaker test failed. Cache test failed. Multiprocessor Dispatch test failed. Interprocessor Communication test failed. Installed devices test failed. Recommended Action Replace the processor board and retest. For error codes 103-xx through 106-xx, replace the processor board and retest. The following steps apply to error codes 107-xx through 109-xx. 1. Replace the battery/clock module and retest. 2. Replace the system board and retest. For error codes 110-xx through 113-xx, replace the processor board and retest. 1. Verify the speaker connection and retest. 2. Replace the speaker and retest. 3. Replace the system board and retest. Replace the system board and retest. The following steps apply to error codes 122-xx and 123-xx. 1. Check the system configuration and retest. 2. Replace the processor board and retest. 3. Replace the system board and retest. 1. Check the system configuration and retest. 2. Verify cable connections and retest. 3. Check switch and/or jumper settings and retest. 4. Run the System Configuration Utility and retest. 5. Replace the processor board and retest. 6. Replace the system board and retest.